Home
Hardware Installation Guide
Learn how to install and connect your Synergis Cloud Link appliance.
Connecting Mercury interface modules in Synergis Cloud Link
Connections for Mercury interface modules
You can connect peripheral devices such as readers, the IP network, and AC power source to your Mercury interface modules.
Mercury MR16in connections
As part of your Synergis™ Cloud Link installation, you might need to include a Mercury MR16in interface module.

Release Notes
Learn about the Synergis Cloud Link release.
Hardware Installation Guide
Learn how to install and connect your Synergis Cloud Link appliance.
- Preface
- Introduction to Synergis Cloud Link
- Mounting and connecting the Synergis Cloud Link
- Synergis Cloud Link 312
- Connecting Mercury interface modules in Synergis Cloud Link
  - Connections for Mercury interface modules
    You can connect peripheral devices such as readers, the IP network, and AC power source to your Mercury interface modules.
    - Mercury MR16in connections
      As part of your Synergis™ Cloud Link installation, you might need to include a Mercury MR16in interface module.
    - Mercury MR16out connections
      As part of your Synergis™ Cloud Link installation, you might need to include a Mercury MR16out interface module.
    - Mercury MR52 connections
      As part of your Synergis™ Cloud Link installation, you might need to include a Mercury MR52 interface module.
    - Mercury MR50 connections
      As part of your Synergis™ Cloud Link installation, you might need to include a Mercury MR50 interface module.
    - Mercury LP1501 connections
      As part of your Synergis™ Cloud Link installation, you might need to include a Mercury LP1501 intelligent controller.
    - Mercury LP1502 connections
      As part of your Synergis™ Cloud Link installation, you might need to include a Mercury LP1502 intelligent controller.
    - Mercury LP2500 connections
      As part of your Synergis™ Cloud Link installation, you might need to include a Mercury LP2500 intelligent controller.
    - Mercury LP4502 connections
      As part of your Synergis™ Cloud Link installation, you might need to include a Mercury LP4502 intelligent controller.
- Additional resources for Synergis Cloud Link
Administrator Guide
Learn about Synergis Cloud Link hardware and software.
Glossary
Where to find product information
You can find our product documentation in the following locations:
Technical support
Genetec™ Technical Assistance Center (GTAC) is committed to providing its worldwide clientele with the best technical support services available. As a customer of Genetec Inc., you have access to TechDoc Hub, where you can find information and search for answers to your product questions.

Mercury MR16in connections

2024-07-04

As part of your Synergis™ Cloud Link installation, you might need to include a Mercury MR16in interface module.

The following diagram demonstrates how to connect the module.


A	Inputs	16 general-purpose, programmable-circuit type.
B	Address switches	Used to set the device address. For more information on address settings on the Mercury module, refer to the manufacturer's instructions.
C	Line termination	For modules at end of line, install jumper for 120 ohm line termination (J2 is not used).
D	RS-485	RS-485 bus connection to other Mercury modules.
E	Relay outputs	MR16in: 5A inductive, 0.6 PF MR16in-S3: NO: 5A, NC: 3A, inductive, 0.6 PF
F	Power In	Connect + to VIN (observe polarity). Connect - to GND. Use 20 AWG wires minimum.