2022-02-10Last updated
Before you can configure a Synergis™ Cloud Link unit, you must
perform some pre-configuration steps.
Procedure
-
Read the Synergis™ Cloud Link Release Notes for any known issues and other information about the
release.
-
Have a computer equipped with a network card, Ethernet cable, and a web
browser.
-
(Optional) Have the IP address assigned by your IT department to the Synergis Cloud Link unit.
-
Configure the hardware settings (DIP switches, address dials, etc.) to their final
position on the interface modules.
-
Connect the interface modules to the Synergis Cloud Link
unit through the proper communication channels.
Note: Because each hardware manufacturer uses a different communication protocol, all
interface modules connected to the same RS-485 channel must be from the same
manufacturer.
-
Physical devices (REX, door sensors, etc.) should be connected as well, but can be
replaced by test switches and LEDs during the configuration phase.
For more information, see the Synergis™ Cloud Link Hardware Installation
Guide.
-
Download the latest Synergis Cloud Link package from https://portal.genetec.com/support.
-
Install and configure Security Center with
at least one Access Manager role.
For information about deploying Synergis™, see the Security Center Administrator
Guide.
